Communicate with Supplier? Supplier
April Ms. April
What can I do for you?
Contact Supplier

Shenyang Guide Rubber Products Co.,Ltd

Industry Information

Home > Industry Information > Specification for the use of insulating glass butyl rubber and insulating glass aluminum strip

Specification for the use of insulating glass butyl rubber and insulating glass aluminum strip

2020-02-14


Hollow glass butyl rubber is a one-component, solvent-free, non-fogging, non-vulcanizing, non-vulcanizable, first-class encapsulant for insulating glass based on polyisobutylene rubber. Hot-melt butyl sealant maintains its plasticity and tightness over a wide temperature range without cracking or hardening. Due to its extremely low water vapor transmission rate, it can be combined with an elastomeric sealant to form an excellent moisture resistant system. Features: good sealing effect, easy to guarantee quality; no need for curing period, saving floor space and reducing production cost; it is environmentally friendly, no waste, and clean environment.
Hollow glass butyl rubber is a must-have for the first sealing of insulating glass with two-component polyurethane sealant, two-component polysulfide sealant, two-component silicone sealant and hollow glass hot melt adhesive. According to the size of the insulating glass butyl rubber coating machine, different specifications of hollow glass butyl rubber are selected. When making hollow glass with hollow glass butyl rubber, pay attention to:

1. Clean the insulating glass and aluminum spacers for use.

2. Put the butyl hot-melt sealant into the extruder cylinder and preheat it to 130-140 °C. After the thermostat is kept at a constant temperature, when the strip is tested and the line is evenly continuous, the strip is applied to the hollow glass aluminum spacer. On the trough, after a little cool, it is pressed into a semi-finished hollow glass with clean glass.

3. After the outer sealant is applied and cured, it is the finished hollow glass.

4. When using the imported fast glue machine, the temperature of the rubber cylinder should be increased by 10-15 °C, and the extrusion pressure should be adjusted from 150Mpa to 170-200Mpa, and the Rubber Strip should be evenly distributed.

Note: When using butyl hot-melt sealant, keep your hands clean. Do not put dust, oil and solvents (such as acetone, gasoline, etc.) on the surface of the glue. Wear a lint-free glove when applying glue. Be careful to burn when in contact with hot glue. Gloves that come into contact with glue should be clean and free of burrs or other contaminants that tend to stick to the glue. When the butyl hot-melt sealant is glued, it should be controlled below 160 °C. It is strictly forbidden to glue at 170 °C or above to avoid aging and decomposition of the glue.



Specification for use of hollow glass butyl rubber and hollow glass aluminum strip

Send Inquiry

Tel:86--82911038

Fax:

Mobile Phone:+8613407111142

Email:april.gu@guiderubber.com

Address:HONGBIN ROAD 5#,YUHONG AREA,SHENYANG, Shenyang, Liaoning

Mobile Site